Hello
If someone could help me I would be very grateful.
I have to make a carter for a tattoo studio. I send you a photo but when I upload it to easel do not know all the lines. also transform it to svg and it goes wrong.
HOW TO MAKE IT GOOD OUT
Load picture into this website and save as SVG http://www.vectorization.org/
All I did was load the 2nd picture.
I get good results with this site:
I usually use put 1200 in the DPI option.
hi
thank you very much.
that’s what I did but the fine lines do not work out well when I do it in the xcarve with a 90-degree beat.
Thank you all for helping me with this project. In the end I made it easier and changed the font a little and canceled some things but the result went well. Thank you very much to all
Ummm…
Unless I missed something, you might need to check your spelling before handing it to the customer
And already painted up, too…
The things that make you say “O”.
Tattoo
I figured he would have found it.
Jajajaa
I’m stup … It’s dyslexia
