Flatting Bit

Projects
1

I need to flatten some mesquite wood with some epoxy parts. I was wonder if any of you have a flatten bit and what type?
What setting do you use on the X carve?

The project is Cheese Board with some engrave on the finish project. 18.5 inches in length and 9.5 inches in width

I was trying to put the link from my easel into this question however I need more coffee to figure that out.

Thank you in advance

Joe

2

I usually use a 1/2" and sometimes a 3/4" diameter straight bit, but a bowl bit would leave a better finish I think. That said, I only have flattened wood, not epoxy.

flatten
flatten762×428 61.9 KB

flatten2
flatten21027×447 109 KB

3

thanks and nice looking guitar neck

4

Thanks, it’s a Gibson rebuild project:

neck in body
neck in body1175×425 160 KB

5

I really like that. I want to make one of those for my son out of black walnut