new to x carve and easel everything is good and going great z probe works great with evry bit except 1/32 bits it just goes and breaks and z probe keeps going down i have to stop probing to stop itgoing down. im scared to try it again i looked into the forum but couldnt find any info in regards wondering if im doing something wrong or if theres something im missing thank you
1 Like
Your not doing anything wrong those bits are very fragile. If you look at them wrong they will break. If you can get away from that small of a bit and use a vbit you will be better off. Or if you have to use it try probing with a piece of paper where you can slow the z way down on how much you go down.
4 Likes
thank you as i say its new to me i will manually probe the smaller bits i just wanted to ask the question so i could determine self error or something else i appricate the response happy carving
2 Likes
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.