is there a way i can get the zero spot to be the top left corner instead of the bottom left. i want the spindle to go up and to the left when it is done carving and get up and out of the way
https://community.inventables.com/t/phils-help-documents-and-tutorials/29460/114
Take a look at this if using Easel…may be what you are looking for.
1 Like
Yes, the quickest way will be to zero of your top left corder of part, jog the spindle 2" further inward/to the left and specify that as your Home Position.
Then in Easel assign the top left corner of your material following coordinates X+2inch and Y-2inch.
However, I either just jog the spindle out of the way after a carve, or use G28/G30.
thank you very much