Hello Everyone, I am new to the CNC world and I finally have my 1000m running. Tried to cut a sample at 4" x 4" and it cut the project at 6" x 6". Is this a software issue, would appreciate any suggestions. I did look at my steppers as someone gave me that suggestion and that was not the problem.
Have you run through the initial setup process in Easel?
Here is a video by @PhillipLunsford that discusses calibration of the X-Carve if you need to do that.
{:0)
Brandon Parker
1 Like
FYI, same concept descried in another video i sent him in a different thread: New XCarve Owner Back Again - #4 by SethCNC
John said it didn’t need re-calibration, but TBH unless the size he’s reading is coming from a bounding box (like t does with typed text) then i’d think it’s a calibration issue
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.