X-Carve Pro hitting t track wing nut clamps

1

I’ve been using the wing nut hold down clamps that came with my X carve pro and have found the dust shoe hits them if I am carving a full 4’ X 4’ sheet. I need to leave about 2-3” on the left and 3-4” on the right or I risk hitting the nut.

Anyone have recommendations for clamps that are low profile enough to not hit the dust shoe but fit in the t track area that run along the sides of the waste board?

2

There are a lot of " carve yourself" clamp designs on the projects page (link at the top of the forum)

Or I’m not sure how well the ones at pwn fit in those surrounfing sides on the XCP, but that’s another option many other cnc users like

3

This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.