What is the recommended feed rate and depth per pass

1

I’m currently carving on HPDE with a 1/16" upcut fishtail bit. What is the recommended feed rate and depth per pass with that combination?

Would be great if there was a cross-reference table with drill bits x material that had these settings. The material is too expensive to do trial and error.

2

Easel recommends the following, always best to start off there and adjust and tinker up from there IMO.
B-

3

thanks Brian, appreciate that!

4

For plastics, I would start with half the diameter of the bit (in this case .032) and 30-40 ipm.

I might even go .02 deep and run it up to 60.