I am trying to make clamps, and I noticed that the X and Y holes are spaced different.
Does anyone know the measurements of the holes? I tried to measure with a caliper and failed.
Regards,
Rick
if you go to the projects page, this should help
For the x-carve pro. Not the original.
If you email tech support theyll forward the pdf of the model, its missing a few measurements. But the hole spacing is there… email tonight and youll probably get the file back tomorrow am
2 Likes
Thank you, I did. and I subscribed to your channel too!
Regards,
Rick
1 Like
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.