Want to create increasing depth on a single pass

Projects
1

I want to cut a line, 10" long, start at a cut depth of .02, and end at the finish of the same line at .05, in a single pass; So the Z axis actually goes deeper as the bit moved down the cut (cut pass will be deeper on one end, than the other). Is this possible?

2

Check out this app in Easel. You can tweak it to get what you want.

image
image440Ɨ416 9.28 KB

1 Like
3

Shim one end up 0.03?

3 Likes
4

Thanks mark, want to try and stick with the software control measure. Iā€™m going to see what the app above does

5

I used the app a couple times I had to change my stepover, and run a few tests to get it right

6

If you have access to VCarve Pro or Aspire it is very easy.