I am a newbie here, hello everyone.
I just bought and set-up my new Masuter3. After reading and reading I have programmed and cut a simple design, my name, Alan and a hummingbird on a piece of MDF that measures 7"x3.5". The bird is on the left side, name on the right. It does a wonderful job cutting the bird, moves over to start the “A”, makes a few passes, then just stops. Spindle stops turning and moving.
I looked at my programming and it looks good. But remember, I am a rookie and not 100% sure what I’d be looking for.
All help would be appreciated. Links to videos especially.
TIA
Alan
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.