hi im not sure where else to ask this.i was using the desktop router to engrave an image,ive had to do this in sections but the computer crashed,as I have gone back onto easel software the full image isn’t there,is there anyway of pulling this back,ive tried going to undo remove but it isn’t there
I think its lost.
To avoid getting into a similar situation next time, dont work off the source project. Duplicate the whole project and use that as a source for splitting it up. That way you dont touch the source project, just a "work file " off the source file.
1 Like
thankyou for your reply,i still have 3 more of the same to engrave and was hoping it wasn’t lost