Laser rollers

[BrandonR_Parker]

You might check out this thread…

Xcarve, jtec laser, FTG rotary - Help/Questions/suggestions

Looking for help/suggestions in setting up a new rotary with an Xcarve , FTG rotary and a Jtec laser. Hardward specs: XCarve 1000 (2018) xcontroller with upgrade Z axis Increases gantry clearance to 4.5” Jtect Laser 7w or 2.8w FTG K40 Rotary - Using original Inventables stepper motor NEMA23 140OZ/IN 2.8A STEPPER (KL23H251-28-4A) 140 oz in. Single Shaft 1.8° /200 Steps Per Rev. Software: Lightburn is setup already working with a laser Easel gcode settings currently down below, as part o…

{:0)

Brandon Parker