I got my X-Carve 1000mm kit at the end of November and just finished the assembly. I looked it all over and pushed a few buttons and it seems to be working. Tomorrow I will go over everything and see where those extra parts go. Yes, I had some extra screws I am not sure where they go.
I have extra holes in the Side Board that I think are just for addons for later. I am sure there may be one screw I left out somewhere. I have too much hardware left over to think I missed a bunch of steps.
While Iām looking over all the steps to see if I missed something, I will be thinking about what my first project might be. Yes, I must make sure the thing is square and calibrated before I try making anything too important.
Well, I need to get some rest, tomorrow is going to be a busy day. 
