Thanks I saw the mm and switched it and it went to 1hr and 35.
1 Like
I ran it at the 90% and now I’m doing the 40% which it taking out the parts left from the 90. I did notice that you can see that either the spoil board is uneven or the second was not flat. But once that done it should be even and then I can do a test cut
If you have lines in the skim,then that means your gantry is not perpendicular to your wasteboard
Oh ok is there a way to fix that.
First, if it is very slight bit off just sand the project. If it is bad you will need a square and adjust the gantry at the end points. The square is used to establish the correct perpendicular status
Oh ok is there a way to fix that.
Oh ok. It’s not bad at all but I will check to see if it’s square.
If you need to tram your spindle the here is one way to dial it in, Use shims.
But dont bother if your carves dont require it 
2 Likes