GRBL inspector commands

[ScottBair]

Is there a way that you can control the x-carve directly through the inspector? Can someone point me to those commands? I am unfamiliar with using those in the GRBL settings command prompt. I want to do some calibration and I need to tell the machine to move a certain ammount of mm etc. for X . What would I type in to make it do that? Thanks!

[NeilFerreri1]

How do I tell X carve to move w/ command line?

Depends on how you want it to move, but… G0X10 will perform a rapid motion TO the location, X10, in your current work coordinate system by default. G91 G0X10 will move the X ten units to the right because G91 sets relative motion mode. G90 sets absolute, the default. Careful switching to relative. G0 is rapid G1 moves at defined feedrate (must have one defined) Those are the basics.