AlexC1
January 10, 2018, 8:04pm
1
Hi there,
The dewalt spindle on my x-carve has a lot of left-to-right play. Here’s a short video of it:
https://gifs.com/gif/dewalt-spindle-play-1rQr9P
I get the sense that the wheels aren’t tight enough on the track or something, but not entirely sure. Anyone see this before?
Thanks.
V-wheels should be tight enough to not spin with one finger. That’s a lot of play.
AlexC1
January 10, 2018, 8:50pm
5
The machine is in a maker space, I didn’t set it up in the first place or anything. But I’m trying to take care of it. So any guidance would be helpful.
I take it this may be an inappropriate measure?
AlexC1
January 10, 2018, 9:06pm
7
All set now, I realize now there’s eccentric spacers on there I was able to tighten. Wasn’t obvious at first.
4 Likes