Carriage Skipping Steps

[AbearDesign]

This is a link to a bunch of helpful threads. Also if you are running the rpms to fast, it will dull your bit.

But voltage makes sense. There is a section which goes over calibration and has a video on adjusting the pots

Consolidation of problems/solution threads

I am working on consolidating the most helpful post on various subjects in order to make finding solutions to common issues easier. When I was fresh to the machine and it’s problems, I had to figure out how to word the searches in different ways in order to find solutions. I am still finding older post that were worded slightly different that didnt show up in my original searches. For now, it is just links to the post, however, I plan on creating more of a at a glance problem/solution referen…