Looking to sell my 1000mm x 1000mm X-Carve (LESS THAN 100HRS OF USE). I am located in the central Ohio area and purchased the machine a little over a year ago. The machine is “fully loaded” with the inventables dust collection shoe and 2-1/4 inch hose for shop vac or dust collector attachment, Z-Probe, inventables clamps / brackets, dewault 611 router, and inventables stepper controller. I’ve mounted and routed all components to the underside of a perfect sized table. All wires pass through the table where they have been wired into the x carve controller. The Dewault router also is routed through the table where it plugs into a 110v 20A plug. Both the x carve controller and the plug for the router are then wired into a terminal box where they are joined into a single male plug for a 110v outlet. The single plug is also wired through a switch mounted on the front of the table to easily turn off the entire system. None of the wiring affects the equipment and can easily be sold without custom table. Selling all items listed and pictured below:
- X-Carve 1000mm x 1000mm system
- Inventables dust collection attachment with include hose (full factory length), and dust shoe with extra insert
- X-Carve Z-probe system with extra probe
- Inventables Clamps and Brackets
- 1 1/8in upcut bit (grey), 4 1/16in fishtail 2f (blue), 2 1/8in fishtail 2f (green), 2 1/32in downcut fishtail 2f (pink), 2 1/32in fishtail 2f (white), 2 .01in engraving bit (orange), 1 90 degree v-bit (peach), 1 60 degree v-bit (navy)
- dewault 611 router with 1/8in precision collet for all bits listed above with precision collet tool
- Custom built table ( 45in x 45in x 32.5in to the top of the waste board )
Am asking $2000 for everything. Willing to negotiate price. Pick up only - no exceptions
