Z probe wrong height

[RonSabourin]

@BrentBousquet

s there a reason it raises up so high after I use the z probe.

@ErikJenkins

Did you set the height of the Z-probe in setup?

Hi Brent… likely what Erik mentioned… check this out …

Z probe issues

Tried using my z probe for the first time today and was pretty excited to do so since I have a 2-stage carve. went thru all the set-up steps for my project in “carve” and when it asked if I was using the z probe I went thru those steps. when the carve started, z moved down a bit x, y moved into position and then z went down and started carving air… So at this point I figured I needed to set the unit up before a carve so I went into “set-up your machine” and went thru all the steps there, then w…