# XCarve Build Instructions 2016 model

**URL:** <https://community.inventables.com/t/xcarve-build-instructions-2016-model/149891>\
**Category:** Assembly\
**Created:** [December 23, 2023, 9:56pm UTC](https://community.inventables.com/t/xcarve-build-instructions-2016-model/149891 "2023-12-23T21:56:36Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![BrandonR\_Parker](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/brandonr_parker/32/13853_2.png) [@BrandonR\_Parker](https://community.inventables.com/u/BrandonR_Parker)\
**Post date:** [December 24, 2023, 2:36am UTC](https://community.inventables.com/t/xcarve-build-instructions-2016-model/149891/2 "2023-12-24T02:36:43Z")

</div>

Welcome!!

1. That looks like the correct link to me.

2. A good Saturday should suffice for assembly.

3. I would purchase the dust shoe setup at least.

4. Read through the forum when you have time.

Check out this post as well…

> [@Multiple depth carve](https://community.inventables.com/t/multiple-depth-carve/88527/2):
>
> Do you have the X-Controller? If you do, you should open it up and check the Dip Switches for each axis. Dip Switch 4 should be set to the OFF (Down if viewed with numbers on bottom or left in the image as shown) position as shown in the image below. [Capture] You will also need to ensure that parameter $1 in the GRBL settings is set to 255. {:0) Brandon Parker

Take care to not route the USB cable next to the spindle power cable.

{:0)

Brandon R. Parker

---

_[View the full topic](https://community.inventables.com/t/xcarve-build-instructions-2016-model/149891)._