X-carve 500x500 mm, cut large pieces

[EmilianoMolina]

I describe how I did this to make a table here:

Open Desk layout table build

Hi all, A while ago I posted about a table I wanted to build using my x-carve. At the time I had produced a model to make sure I had my Fusion 360 project set up properly. That original thread is here. Since then I’ve gone and cut out the full-size table. It went well, there were no big issues. The only places where it could have gone wrong were in moving the work from the first position to the second position when cutting pieces that were larger than what the x-carve could fit. Those wer…