Inventables Community Forum

X-axis getting it go 100mm, but instead it go's 200mm

X-Carve Troubleshooting

GlennMDutcher May 21, 2016, 5:34pm 4

Sound like a jumper setting?

Topic		Replies	Views	Activity
Unusually High Z step/mm Setting Troubleshooting	5	2143	April 15, 2020
Z Axis not moving correct distance Troubleshooting	7	3360	September 27, 2016
SOLVED X & Y axis moving too far. gShield microstep jumpers or software step/mm issue? Troubleshooting	21	8546	September 20, 2015
Z steps 1/4 of what they should be Troubleshooting	25	3858	October 20, 2017
Z-axis doesn't cut deep enough Troubleshooting	2	1480	December 11, 2016