What are your thoughts on a Digital Position Readout?

[Earwigger]

Or you could:

New Calendar for the New Year!

@DavidWestley - On large, complicated jobs like this, I will chuck a v-bit into the spindle and put a .2" hole at 0,0. THen, if something goes wrong, I can manually move the bit into this hole, nestle it in, and reset x,y zero. REMEMBERING to do this before you start a big job is the hard part. Also, this assumes you are starting 0,0 in a corner and not in the center. Unless you don’t mind a divot in the middle of your piece. Also, I always screw my work down through the piece into the wast…