Universal G-Code Sender not talking to X-Carve?

[LarryM]

@MitchPeacock

Mitch, you might want to check out this thread.

UGS showing Alarm error only when Homing is enabled

Don’t know if this is just the way things are in UGS (…and I do mean Universal G-Code Sender) but whenever I have our 500mm machine setup to allow homing, I have to unlock UGS because the alarm is going. I may be wrong, it does happen, but I thought that that UGS would use the Limit switches for more than a homing mechanism. If it had worked the way that I thought that it would I would not have a Z axis switch in 12 pieces. I’ve looked for solutions wherever the net has taken me (believe me, …