# Troubleshooting connectivity after emergency stop

**URL:** <https://community.inventables.com/t/troubleshooting-connectivity-after-emergency-stop/100685>\
**Category:** X-Carve\
**Created:** [September 27, 2020, 7:36pm UTC](https://community.inventables.com/t/troubleshooting-connectivity-after-emergency-stop/100685 "2020-09-27T19:36:03Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![Ashley2](https://avatars.discourse-cdn.com/v4/letter/a/c68b51/32.png) [@Ashley2](https://community.inventables.com/u/Ashley2)\
**Post date:** [September 27, 2020, 7:36pm UTC](https://community.inventables.com/t/troubleshooting-connectivity-after-emergency-stop/100685/1 "2020-09-27T19:36:03Z")

</div>

The software is recognizing the x-controller after emergency stop. Help?

---

<div class="post-metadata">

**Author:** ![BrandonR\_Parker](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/brandonr_parker/32/13853_2.png) [@BrandonR\_Parker](https://community.inventables.com/u/BrandonR_Parker)\
**Post date:** [September 28, 2020, 1:58am UTC](https://community.inventables.com/t/troubleshooting-connectivity-after-emergency-stop/100685/2 "2020-09-28T01:58:20Z")

</div>

Have you reset the E-Stop button all the way?

{:0)

Brandon Parker

---

<div class="post-metadata">

**Author:** ![HenryFeldman](https://avatars.discourse-cdn.com/v4/letter/h/977dab/32.png) [@HenryFeldman](https://community.inventables.com/u/HenryFeldman)\
**Post date:** [September 28, 2020, 2:58pm UTC](https://community.inventables.com/t/troubleshooting-connectivity-after-emergency-stop/100685/3 "2020-09-28T14:58:21Z")

</div>

I had that exact problem which was inside the e-stop switch it can get stuck in the off position. If you pop the bottom off the switch you can mechanically see what’s going on.

 ![installEStop (1)](https://canada1.discourse-cdn.com/flex009/uploads/inventables/original/3X/1/e/1eda820a3db01d1046c013bd24863af45c05530e.gif)