Trouble with Y axis

[TravisLucia]

I had similar issues, follow these steps and it should make everything square!

Y Axis stopping with motors still running (Fixed)

I’ve had a relatively inconsistent issue with my Y axis. When I set it to move forward or back it will move a few inches and then you can just hear the motors trying to move but nthing is physically moving. I’m sure its a belting issue because I took the belts of and ran the motors and they run together and relatively smooth. I’ve tried loose, tight and in between with the belts, no consistent results. Not sure if it’s relevant but the green light for the Y axis on the g shield dims and goes ou…