Tools Needed for Install

[sketch42]

Fo those coming here looking for more tips about the extra tools you may need or that may help along the way, check out this thread here:

User Assembly Tips

There might already be a place for tips for assembly but I could not find it so… As I assemble the different carriages I started using a small non-marring vise to hold the carriage still while aligning and tightening parts -much easier than trying to hold the carriage or plate and a tool for each side, try it! BE SURE you use a vise that wont leave marks and don’t over tighten it and only tighten on a flat plate with no parts being clamped! When building the Y plates (2) , I had better lu…