To MDF or not MDF... that is the question

[JkWestphal]

OUCH!

@AngusMcleod

I just bought a sheet of ¾" last week, and it was $99.99 plus $1 per cut, but you get the first cut free. I buy from a local store.

[X-CNC]

@AngusMcleod

Here is a shot of my torsion-box after finishing with sanding sealer and water-based poly.

Looks nicer than my dining room table

[X-CNC]

@AngusMcleod

This was to bring them to the exact size needed to fit the end-rings I bought from Amazon.

Does anyone know where you can buy these? I searched Amazon/Home Depot/Loews but can not locate them. I also searched under PVC end-ring/PVC trim rings but still no luck

[X-CNC]

Thanks Angus. I just ordered them

@RobH

Paint bubbling on the end plates that aren’t aluminum so watch for that problem in the future.

Disappointed to hear about this. Might have to powder coat them if I see this happening.