# Setting Tool Zero the Easy Way **URL:** \ **Category:** X-Carve\ **Created:** [April 15, 2017, 1:57am UTC](https://community.inventables.com/t/setting-tool-zero-the-easy-way/36543 "2017-04-15T01:57:23Z")\ **Posts on this page:** 1\ **Showing post:** 4
**Author:** ![RobertMcdermott](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/robertmcdermott/32/72487_2.png) [@RobertMcdermott](https://community.inventables.com/u/RobertMcdermott)\ **Post date:** [April 16, 2017, 12:17am UTC](https://community.inventables.com/t/setting-tool-zero-the-easy-way/36543/4 "2017-04-16T00:17:07Z")
This one? [Triquetra UGS Error](https://community.inventables.com/t/triquetra-ugs-error/33712) Or this one? > [@Triquetra CNC Shop Destroyed by Storms](https://community.inventables.com/t/triquetra-cnc-shop-destroyed-by-storms/35868): > > We had some severe storms pass through here about 3:00 am and my shop was for the most part destroyed. I do still have two Triquetra Touch Plates available at this time that I can ship out. Once those two are gone then I won’t be accepting any new orders until I can rebuild. I don’t have a time frame at this time. My website is tracking my inventory so if your order for a Touch Plate is accepted then it will be shipped out normally. Once the inventory is exhausted then no orders will be accepte… Or maybe this one? > [@Triquetra touch plate issues](https://community.inventables.com/t/triquetra-touch-plate-issues/24560): > > Hi anyone using the triquetra touch plate out there having the same problem as me? after running g code to set the touch plate to 0. the bit never touches the touch plate? I was just showing people a cheap and easy way to set their machines in a repeatable manner, so my bubble isn’t likely to burst. I wish Charley all the luck in the world. --- _[View the full topic](https://community.inventables.com/t/setting-tool-zero-the-easy-way/36543)._