Routing Using X-Carve

[Rusty]

You could do this, it would depend on the software you are using and if you have the right bits. I posted about a work around that you could do with Easel, it depends on how complicated you want to get.

Bevel a cut out part?

I did a quick sketch and it looks like if you have a 90deg v-bit all you have to do is tell Easel that your bit is twice as wide as your chamfer leg and your depth of cut is also the length of your chamfer leg. For example if you want a chamfer that’s 1/8" x 1/8" you would tell Easel you’re using a 1/4" bit, your depth of cut would be at 1/8" and you would cut on the path. See diagram below. [image] With this logic, if you want a 1/4" x 1/4" chamfer your bit would be 1/2" at a depth of 1/4" o…