[Resolved] Boned my Arduino - Need help setting up Grbl

[AlanDavis]

If my post didn’t help, go to this link and see what steps we go for exact same problem. If you don’t erase your eprom, doesn’t take anything else. When you upload correct hex file you don’t have to work on those numbers.

[Solved] X-Carve enlarging image

My X-Carve acting bad, anything on the Easel drawing or VCarve pro drawing enlarging output 8 to 9 times bigger when its carving. Support sent me hex file, no help. All control fine, homing is good, machine setup is good. GRBL Controller, Universal Gcode sender and Easel doing same thing. Output image is huge, hitting side wall. Heeeelllpp.