Rapid collision with stock

[Thor]

any chance someone got some tips here:

Not aligned with the homing switch

New problem here. Now when I home ($h) the bit is no longer right above the fysical switch. I can see when I starts to carve and it goes down to hit the height-switch it will hit the smartclamp instead. what now? settings from machine inspector: $0=10 (step pulse, usec) $1=255 (step idle delay, msec) $2=0 (step port invert mask:00000000) $3=0 (dir port invert mask:00000000) $4=0 (step enable invert, bool) $5=0 (limit pins invert, bool) $6=0 (probe pin invert, bool) $10=3 (status report …

my machine is out of commision. the thing can’t hit the height detection button longer…