Question about repeatability of missed steps

[RandyHawkins]

@ChrisRice

What belt did you replace

The x one

Belt broke

My x-carve is rather new - got it back in May. It prob has no more than 8, possibly 10, hours of carve time on it. Early on I tensioned the belts and was going to again soon as, it is my understanding, they will stretch. In the middle of a lengthy carve today the x belt broke right at the x motor’s wheel. (Is that typically where a break occurs?) The belt itself shows no signs of wear or stress. I don’t remember what I tensioned it to but wouldn’t have done more than I read here in the forums…