Protective Cover on Dewalt 611

[BrandonR_Parker]

Check out this thread as well; there’s a post from me about the Dip Switches within the X-Controller in case you have it.

Multiple depth carve

I’m having a hard time keeping zero when changing bits and adding or removing the dust boot. Everytime I change the bit it causes the drill to move. Even when adding or removing the dust boot, the drill will move. I have tried the switches inside that I was told by support would lock the motors but didn’t. I’m carving the first step with a 1/8 bit and the second with a 1/16 it’s always off after a bit change

Also, “not in a dusty environment” … Hahaha… I am chuckling as my X-Carve blows through MDF (spoken Glue-Covered-Dust). Making things on the X-Carve will change that!! Invest in dust removal and control for the X-Carve and your shop if you have not already.

{:0)

Brandon Parker