Problems with UGS... Any alternatives?

[LarryM]

@ScottWilkins

Most of the S values in your G-code file are less than 30. 30/255 is about 11 percent power. There are some values above 100.

Check this thread:

Xcarve_JTech_grbl (usage notes)

For those of you that use multiple programs to send your g-code to the X-carve remember that the grbl settings are persistent even through a power off cycle. Be careful to make sure that you have the correct parameters loaded into grbl when you start a laser or spindle job. If you use PicSender exclusively, all you need to do is to select the applicable mode and PicSender will take care of loading the proper grbl parameters for that job. If you leave PicSender to use an alternate method of send…