Not carving deep enough

[NeilFerreri1]

@DanielBoshoff

if it is not travelling the desired distance as required, then what must you do to correct it?

Adjust the steps per mm.

My bed is too tiny?

In Easel, go to the machine inspector and type $$. That will give you your grbl settings. The X axis steps per mm is stored in the $100 parameter. Y is $101 and Z is $102 Lets say your setting is currently 250.000, you try to jog 50mm and it actually moves 12mm. Expected/actual*current steps per mm = your new steps per mm. So, 50/12 = 4.1667. That times 250.000 = 1041.667. You’d enter $100 = 1041.667. Repeat the tests until you get it dialed in. I’d jog as far as you can, and make sure you …