# No internet Software solution

**URL:** <https://community.inventables.com/t/no-internet-software-solution/16487>\
**Category:** X-Carve\
**Created:** [November 28, 2015, 1:32pm UTC](https://community.inventables.com/t/no-internet-software-solution/16487 "2015-11-28T13:32:03Z")\
**Posts on this page:** 1\
**Showing post:** 13

<div class="post-metadata">

**Author:** ![BillArnold](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/billarnold/32/48170_2.png) [@BillArnold](https://community.inventables.com/u/BillArnold)\
**Post date:** [November 29, 2015, 2:44am UTC](https://community.inventables.com/t/no-internet-software-solution/16487/13 "2015-11-29T02:44:59Z")

</div>

> [@X Carve Internet needed for Easel can I use Mach 3](https://community.inventables.com/t/x-carve-internet-needed-for-easel-can-i-use-mach-3/15436):
>
> I have just purchased an X Carve 1000 mm and have set up in my workroom Do I have to connect to the internet every time to use Easel? I had already bought Mach 3 and V Carve Desktop can I use these instead of Easel to control the X Carve if so what do I have to do to do this? Please help very new to all of this Belinda

> [@Mach 3 help](https://community.inventables.com/t/mach-3-help/12138/2):
>
> I assume you’re using something like a Gecko control board for your electronics package, and not the grbl/gshield that the X-Carve is typically configured with? If that’s the case, I think the important numbers you’re going to need are the pulley/belt steps per mm. I think there’s a thread with those numbers on it, let me see what I can dig up.

---

_[View the full topic](https://community.inventables.com/t/no-internet-software-solution/16487)._