Need help tried getting picsender to work for jtech and lost easel

[picengravertoo]

Look at the two grbl settings text files Larry posted here.

Xcarve_JTech_grbl (usage notes)

For those of you that use multiple programs to send your g-code to the X-carve remember that the grbl settings are persistent even through a power off cycle. Be careful to make sure that you have the correct parameters loaded into grbl when you start a laser or spindle job. If you use PicSender exclusively, all you need to do is to select the applicable mode and PicSender will take care of loading the proper grbl parameters for that job. If you leave PicSender to use an alternate method of send…

There is some information here also.

(Resolved) Issues configuring 1000mm X Carve grbl settings

Hello all. OK so I finally got my x carve together. I have been testing it with no spindle, just to make sure everything is wired and works properly. I have since run in to a couple issues which I believe are mostly software based. The first issue I had was when sending the test carve from easel to the x carve, it would just run from home to the opposite corner before smashing in to the makerslide. I believe I have corrected this by changing $100 and $101 from 250 to 40. This however caused the …