# Maximum Speeds
**URL:** https://community.inventables.com/t/maximum-speeds/160539
**Category:** X-Carve Pro
**Created:** [February 5, 2025, 6:57pm UTC](https://community.inventables.com/t/maximum-speeds/160539 "2025-02-05T18:57:01Z")
**Posts on this page:** 4
**Page:** 1
### Author:  [@DavidWolfe](https://community.inventables.com/u/DavidWolfe)
#### Post date: [February 5, 2025, 6:57pm UTC](https://community.inventables.com/t/maximum-speeds/160539/1 "2025-02-05T18:57:02Z")
What are the maximum speeds for X and Y on the 4x4 X-Carve Pro? For chip load and carve duration I am looking to carve faster. I cannot locate recommended or maximum speed specs so I am asking here.
Thank you in advance,
David
---
### Author:  [@MichaelColey](https://community.inventables.com/u/MichaelColey)
#### Post date: [February 6, 2025, 5:08pm UTC](https://community.inventables.com/t/maximum-speeds/160539/2 "2025-02-06T17:08:21Z")
Hello,
There are quite a few variables to be able to determine this answer. Have you tried looking up a “feed and speed” calculator online? This way you can enter your specific material along with bit diameter and bit type to be able to determine a good starting point. I’m not sure you are going to be able to enter a specific spindle RPM which is another factor but a calculator should get you in the ballpark.
---
### Author:  [@DavidWolfe](https://community.inventables.com/u/DavidWolfe)
#### Post date: [February 7, 2025, 2:59pm UTC](https://community.inventables.com/t/maximum-speeds/160539/3 "2025-02-07T14:59:11Z")
I use V-Carve Pro and each bit can be adjusted for feeds and speeds and calculates chip load. What I am looking for is the maximum speed for the XCP to avoid belt slippage.
---
### Author:  [@system](https://community.inventables.com/u/system)
#### Post date: [May 8, 2025, 2:59pm UTC](https://community.inventables.com/t/maximum-speeds/160539/4 "2025-05-08T14:59:36Z")
This topic was automatically closed 90 days after the last reply. New replies are no longer allowed.