Machine moving during tool change

[MartinW.Mcclary]

I’d recommend turning off the dip switches. I haven’t had a bit change mess up my position since I did that. This thread may be helpful in that regard.

XController disassembly

OK. I just took a deep breath and decided to find out myself. The short answer is Yes you can do it without taking the whole thing apart. You have to unscrew the front panel screws. The front panel has the 3 white switches. Next you’ll find the Emergency switch has two red wires on it. The wires are soldered to terminals that can pull out when you loosen up the two screws first. The two small screws are retrieved from the bottom of the housing. I thought it was a push on terminal and ya…