# Loss of power on New X-Carve -- Resolved

**URL:** <https://community.inventables.com/t/loss-of-power-on-new-x-carve-resolved/49505>\
**Category:** Troubleshooting\
**Created:** [January 23, 2018, 6:58pm UTC](https://community.inventables.com/t/loss-of-power-on-new-x-carve-resolved/49505 "2018-01-23T18:58:24Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![ScottFolckemer](https://avatars.discourse-cdn.com/v4/letter/s/65b543/32.png) [@ScottFolckemer](https://community.inventables.com/u/ScottFolckemer)\
**Post date:** [January 23, 2018, 6:58pm UTC](https://community.inventables.com/t/loss-of-power-on-new-x-carve-resolved/49505/1 "2018-01-23T18:58:24Z")

</div>

I just recently got the X-Controler for my X-Carve 750. It was almost done with the second cutting and I lost power. The light on the power supply was on but not on the 2 circuit boards.

I called Inventables and there is an issue with the crimps on the E-Stop Circuit. I cut the crimps off, stripped the wires, and reconnected. Everything is working now. Issue resolved, just sharing the info

---

<div class="post-metadata">

**Author:** ![TimothyRoberts](https://avatars.discourse-cdn.com/v4/letter/t/ecb155/32.png) [@TimothyRoberts](https://community.inventables.com/u/TimothyRoberts)\
**Post date:** [January 26, 2018, 3:48pm UTC](https://community.inventables.com/t/loss-of-power-on-new-x-carve-resolved/49505/8 "2018-01-26T15:48:29Z")

</div>

I had the same problem. I replaced a bad connector to the E-Stop button and the X-Controller works as expected.

 ![image](https://canada1.discourse-cdn.com/flex009/uploads/inventables/original/3X/3/0/30a2b2dffe7049fbd91257ddb448316ba348d557.jpg)