# Long gcode files

**URL:** <https://community.inventables.com/t/long-gcode-files/15027>\
**Category:** Uncategorized\
**Created:** [October 27, 2015, 4:49pm UTC](https://community.inventables.com/t/long-gcode-files/15027 "2015-10-27T16:49:06Z")\
**Posts on this page:** 1\
**Showing post:** 10

<div class="post-metadata">

**Author:** ![Tarry\_Brindle](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/tarry_brindle/32/32229_2.png) [@Tarry\_Brindle](https://community.inventables.com/u/Tarry_Brindle)\
**Post date:** [October 28, 2015, 3:11pm UTC](https://community.inventables.com/t/long-gcode-files/15027/10 "2015-10-28T15:11:18Z")

</div>

It sounds like a post processor issue…try the X-Carve Photo Carve post processor (has inches and mm) from this thread:

> [@Photovcarve post processor](https://community.inventables.com/t/photovcarve-post-processor/11355/3):
>
> If those don’t work try these modified ones (Photocarve doesn’t like the ARC variables) Continuing the discussion from [X-Carve photo carving](https://community.inventables.com/t/x-carve-photo-carving/10270/37):

I’ve used these post processors with Photo Carve with success…although I must say that I’ve only used Photo carve 2-3 times thus ar.

---

_[View the full topic](https://community.inventables.com/t/long-gcode-files/15027)._