JTechPhotonic mount for x-carve

[picengravertoo]

We done these with an air assist and a 2.8W 445nm laser diode.

3D Laser Diode Engraving with PicEngrave Pro 5

We have been experimenting with 3D laser Diode engraving here at picengrave dot com. We used PicEngrave Pro 5 to generate the gcode and cut into 1/4" Poplar board. The settings we used is a Pixel Resolution of .006" (step over and step ahead) and a set feedrate to 85IPM. Our Feed Rate Change feature was used to expand the shades to the point it cut into the wood to different depths based on the shading in the image. With the 88% FRC setting we used, the black areas ran at 10.2IPM at full power …