JTech laser/GRBL spindle issues

[LarryM]

If you are using my version of grbl look here:

Xcarve_JTech_grbl (usage notes)

For those of you that use multiple programs to send your g-code to the X-carve remember that the grbl settings are persistent even through a power off cycle. Be careful to make sure that you have the correct parameters loaded into grbl when you start a laser or spindle job. If you use PicSender exclusively, all you need to do is to select the applicable mode and PicSender will take care of loading the proper grbl parameters for that job. If you leave PicSender to use an alternate method of send…

@MichaelRought

Would that suggest in V-Carve to set “spindle speed” to a number between 0-255? so for my S10 setting to set it as 10RPM?

Yes.