# It’s Done! **URL:** \ **Category:** X-Carve\ **Created:** [July 18, 2019, 2:22am UTC](https://community.inventables.com/t/it-s-done/75293 "2019-07-18T02:22:42Z")\ **Posts on this page:** 1\ **Showing post:** 27
**Author:** ![SamGreenstreet](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/samgreenstreet/32/86007_2.png) [@SamGreenstreet](https://community.inventables.com/u/SamGreenstreet)\ **Post date:** [July 21, 2019, 8:15pm UTC](https://community.inventables.com/t/it-s-done/75293/27 "2019-07-21T20:15:11Z")
When I built my workbench, I placed strips of rubber between the top board and the 2x4 frame to absorb some vibrations. I have mine setup in an unfinished room in the basement. Noise isn’t too bad. I would put surge protection on the x-controller and whatever computer you’re using to run it. I ran a seperate power source for my dust collector just to be safe, but there’s no need for the dewalt 611 to be n a surge protector. It doesn’t much mind it one way or another. I made up a simple relay control for my dust collector and spindle. Have a look if you like. Many others on here have come up with even better power solutions. > [@My dust collector and spindle automatic relay control](https://community.inventables.com/t/my-dust-collector-and-spindle-automatic-relay-control/47362): > > I wanted to share my relay control for the dust collector and the spindle. I was originally going to go with the IOT relay that adafruit sells, but it was a little expensive and I would need two of them (because my dust collector is a hog and I don’t want it on the same circuit as the spindle/x-controller). So I decided to build my own. Materials: Solid state relays (x2) [https://smile.amazon.com/gp/product/B00PQ7Y8ZU/ref=oh\_aui\_detailpage\_o01\_s00?ie=UTF8&psc=1](https://smile.amazon.com/gp/product/B00PQ7Y8ZU/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1) 50 mm fan 8 position termin… --- _[View the full topic](https://community.inventables.com/t/it-s-done/75293)._