# Inlay Accuracy and Expectation

**URL:** <https://community.inventables.com/t/inlay-accuracy-and-expectation/13990>\
**Category:** Troubleshooting\
**Created:** [October 4, 2015, 1:07pm UTC](https://community.inventables.com/t/inlay-accuracy-and-expectation/13990 "2015-10-04T13:07:04Z")\
**Posts on this page:** 1\
**Showing post:** 7

<div class="post-metadata">

**Author:** ![AlanDavis](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/alandavis/32/4710_2.png) [@AlanDavis](https://community.inventables.com/u/AlanDavis)\
**Post date:** [October 4, 2015, 2:41pm UTC](https://community.inventables.com/t/inlay-accuracy-and-expectation/13990/7 "2015-10-04T14:41:40Z")

</div>

You may check to see this following post, what’s about fine tuning your equipment.

> [@Steps/mm Calibration](https://community.inventables.com/t/steps-mm-calibration/10705):
>
> I found this video through the X-Carve sub-Reddit ([r/X-Carve](https://www.reddit.com/r/XCarve/)) and thought it might be helpful! [[X-Carve DIYCNC Router - Calibration of steps/mm] ](https://www.youtube.com/watch?v=TzkoMbb9pO8)

---

_[View the full topic](https://community.inventables.com/t/inlay-accuracy-and-expectation/13990)._