# \*homing sequence **URL:** \ **Category:** Troubleshooting\ **Created:** [May 10, 2016, 12:29am UTC](https://community.inventables.com/t/homing-sequence/23536 "2016-05-10T00:29:54Z")\ **Posts on this page:** 1\ **Showing post:** 6
**Author:** ![LarryM](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/larrym/32/51450_2.png) [@LarryM](https://community.inventables.com/u/LarryM)\ **Post date:** [May 11, 2016, 9:21am UTC](https://community.inventables.com/t/homing-sequence/23536/6 "2016-05-11T09:21:47Z")
@GerrySebastian Read these threads and see if you can use the Arduino IDE serial monitor to get the grbl parameters and post them here. > [@Using Grbl - Direct Communication](https://community.inventables.com/t/using-grbl-direct-communication/16073): > > Direct access to grbl. You can interact with grbl directly to isolate problems at the low level. To do so, you need to use a terminal type program to issue commands and get responses from the serial port that has the Arduino attached. Some of the programs are HyperTerminal, Putty, UGS (limited access), and the Serial Monitor in the Arduino IDE, among others. Make sure that you have the correct settings for the program that you use. The COM port where the Arduino is attached should have the … > [@\[Guide\] Using Grbl to debug your homing switches](https://community.inventables.com/t/guide-using-grbl-to-debug-your-homing-switches/16588): > > If you are having difficulties with your homing switches you can do a quick test with Grbl to see what the state of the homing switches is from Grbl’s point of view. NOTE: In order to use this procedure you need to have grbl Version 0.9j or later installed on your Arduino. To do so, you use the Grbl status immediate command ? (question mark). This command asks Grbl for its current value of some of its state information. For the purpose of this article we are interested in the homing switch stat… --- _[View the full topic](https://community.inventables.com/t/homing-sequence/23536)._