Good "show off" project for XCarve?

[MalcolmStanley]

maybe a bit complicated,
but this is what you might call a full stack STEAM project

SO Happy: Finished First Attempt at Antique Reproduction

I posted Periodic Calibration Loss / Z - axis randomly lost steps in middle of a loooong cut - #4 by MalcolmStanley a few days ago about my current carving project: here is an update on what happened next: [Untitled] It turned out that I was losing steps because the two little nuts that hold the gear head to the top of the z-motor cam had wormed their way lose, and when the cam turned the gear was slipping. Once I figured that out, and go them tightened down, magic was ready to happen again: …