Hello,
V-Carve and Aspire are both made by Vectric so I assume the folder is the same. It have GRBL (mm) and GRBL (inch) pp. I select (mm) when I create my toolpath.
If I add your pp to my folder it will not mess up the other?
Then, if you can “teach” me on how to create an appropriate toolpath and how to use UCGS is too much?
No it should appear in the drop down menu as a option.
Check out Vectrics on line tutorials. They are very good and are how I learned how to use their stuff
It might be worth wild mentioning stepover is really only important for pocketing, right?
For relief carving, stepover is crucial. Anytime you are going after a smooth finish.
Good point.
Here’s some additional info from another post:
Discussion on Feedrates
Feedrate Calculator