# Electronics assembly question **URL:** \ **Category:** Assembly\ **Created:** [March 18, 2016, 1:28pm UTC](https://community.inventables.com/t/electronics-assembly-question/21422 "2016-03-18T13:28:10Z")\ **Posts on this page:** 4\ **Page:** 1
**Author:** ![HarryStacey](https://avatars.discourse-cdn.com/v4/letter/h/ec9cab/32.png) [@HarryStacey](https://community.inventables.com/u/HarryStacey)\ **Post date:** [March 18, 2016, 1:28pm UTC](https://community.inventables.com/t/electronics-assembly-question/21422/1 "2016-03-18T13:28:10Z")
Getting close to the end of assembling my X Carve. Is there any trick to aligning and plugging in the g shield? I’ve been at it awhile and can’t seem to find the sweet spot. I have a fear of bending the pins. Also how far down will the g shield move when seated properly? Thanks ---
**Author:** ![ErikJenkins](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/erikjenkins/32/84368_2.png) [@ErikJenkins](https://community.inventables.com/u/ErikJenkins)\ **Post date:** [March 18, 2016, 1:33pm UTC](https://community.inventables.com/t/electronics-assembly-question/21422/2 "2016-03-18T13:33:53Z")
Just take your time, it is not easy. I used a flashlight took my time. It will seat firmly when it is in place. ---
**Author:** ![NathanButler](https://yyz1.discourse-cdn.com/flex009/user_avatar/community.inventables.com/nathanbutler/32/21390_2.png) [@NathanButler](https://community.inventables.com/u/NathanButler)\ **Post date:** [March 18, 2016, 2:55pm UTC](https://community.inventables.com/t/electronics-assembly-question/21422/3 "2016-03-18T14:55:37Z")
As you press down to seat it, try emulating the movement of a coin after you drop it onto a flat surface. Just a little, not too much. Wobble wobble wobble ---
**Author:** ![HarryStacey](https://avatars.discourse-cdn.com/v4/letter/h/ec9cab/32.png) [@HarryStacey](https://community.inventables.com/u/HarryStacey)\ **Post date:** [March 18, 2016, 3:13pm UTC](https://community.inventables.com/t/electronics-assembly-question/21422/4 "2016-03-18T15:13:23Z")
Got it. Guess I just needed to walk away for a few minutes. Thanks